Command and Conquer: Renegade Official Forums: Mod Forum » Need someone familiar with vehicle boning

Home » Renegade Discussions » Mod Forum » Need someone familiar with vehicle boning

Show: Today's Messages :: Polls :: Message Navigator

Re: Need someone familiar with vehicle boning [message #451196 is a reply to message #450888]

Wed, 10 August 2011 13:31

Jerad2142
Messages: 3827
Registered: July 2006
Location: USA

Karma:

General (3 Stars)

Ever thought about just importing it over the bone set of the mammoth tank given to everyone that installs Level editor?
(\RenegadePublicTools\HowTo\Vehicles\Mammoth Tank)

Otherwise all you have to do is bind the turret to the turret bone (which rotates on the Z axis).
The barrels to the Barrel bone (which rotates on the Y axis).

Then you use WWSkin and bind each vertices of the tracks to the closest "wheel" bone to them. (To make the tracks appear to move you have to have a Linear Offset UVMapper on it with a VPerSec value greater than 0).

Finally make sure the take is surrounded with a bounding box that'll hold the barrels no matter what direction they are pointing, and a worldbox that only contains the area that will collide.

Oh, also make sure to pull the wheel bones and tracks up into the vehicle to the point where the suspension length will counter the amount you pulled them up.

Visit Jerad's deer sweat shop

Report message to a moderator

[Message index]

		Need someone familiar with vehicle boning By: Aircraftkiller on Thu, 04 August 2011 16:57
		Re: Need someone familiar with vehicle boning By: NACHO-ARG on Thu, 04 August 2011 20:29
		Re: Need someone familiar with vehicle boning By: sla.ro(master) on Thu, 04 August 2011 23:17
		Re: Need someone familiar with vehicle boning By: Aircraftkiller on Thu, 04 August 2011 23:19
		Re: Need someone familiar with vehicle boning By: Reaver11 on Fri, 05 August 2011 05:30
		Re: Need someone familiar with vehicle boning By: Aircraftkiller on Fri, 05 August 2011 08:47
		Re: Need someone familiar with vehicle boning By: Reaver11 on Fri, 05 August 2011 12:39
		Re: Need someone familiar with vehicle boning By: Aircraftkiller on Fri, 05 August 2011 13:11
		Re: Need someone familiar with vehicle boning By: zunnie on Fri, 05 August 2011 22:37
		Re: Need someone familiar with vehicle boning By: E! on Sun, 07 August 2011 02:09
		Re: Need someone familiar with vehicle boning By: JeepRubi on Sun, 07 August 2011 15:29
		Re: Need someone familiar with vehicle boning By: Jerad2142 on Wed, 10 August 2011 13:31
		Re: Need someone familiar with vehicle boning By: Tunaman on Wed, 10 August 2011 20:08
		Re: Need someone familiar with vehicle boning By: Jerad2142 on Wed, 10 August 2011 21:22

Previous Topic:	renx scale
Next Topic:	How to Turn the Ped on after a specific time

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Jan 04 15:21:56 MST 2026

Total time taken to generate the page: 0.00811 seconds