Command and Conquer: Renegade Official Forums: Mod Forum

Home » Renegade Discussions » Mod Forum » Cutting Terrain with boolean

Show: Today's Messages :: Polls :: Message Navigator

Re: Cutting Terrain with boolean [message #370408 is a reply to message #370396]

Wed, 04 February 2009 06:28

rrutk
Messages: 617
Registered: June 2007

Karma:

Colonel

Yesterday night I found an easy, but only 95& accuracy way...

The first boolean cut with boxes and sphere has always success.

So, just make cutting boxes (large ones, going deep into the terrain) or cutting spheres and cut step by step the shapes/outlines of the buildings.

cut a little bit smaller then the building, so all is fine Smile

[Updated on: Wed, 04 February 2009 06:28]

Report message to a moderator

[Message index]

		Cutting Terrain with boolean By: rrutk on Tue, 03 February 2009 06:43
		Re: Cutting Terrain with boolean By: Titan1x77 on Tue, 03 February 2009 10:29
		Re: Cutting Terrain with boolean By: rrutk on Tue, 03 February 2009 10:45
		Re: Cutting Terrain with boolean By: Altzan on Tue, 03 February 2009 16:16
		Re: Cutting Terrain with boolean By: mrÃ£Ã§Ä·z on Tue, 03 February 2009 16:19
		Re: Cutting Terrain with boolean By: Gen_Blacky on Tue, 03 February 2009 18:23
		Re: Cutting Terrain with boolean By: Omar007 on Wed, 04 February 2009 04:06
		Re: Cutting Terrain with boolean By: rrutk on Wed, 04 February 2009 06:28

Previous Topic:	obelisk ray
Next Topic:	Powerplants

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon Dec 23 22:21:26 MST 2024

Total time taken to generate the page: 0.00715 seconds