Renegade Public Forums
C&C: Renegade --> Dying since 2003™, resurrected in 2024!
Home » Renegade Discussions » Mod Forum » Sciencepark Renegademap
Re: Sciencepark Renegademap [message #362173 is a reply to message #362022] Tue, 09 December 2008 09:32 Go to previous messageGo to previous message
RedOne is currently offline  RedOne
Messages: 60
Registered: August 2006
Location: Netherlands
Karma:
Recruit

Quote:

It does look nice, I agree. But Cabal is right in terms of the procedures of modeling. If you don't try to use the least amount of poly's possible it will come out laggy and large in filesize. If you can learn to model using extrude, weld, and so on, it will be harder to make but will come out ultimately much nicer in the end.


He can be right thats something I wont start a discusion about. Yesterdayevening after his reply I looked back in my files and found where he was talking about i think. But I am kind of a beginner so its a bit new to me. I restarted a few times to do it differtent so my filesize get less high.

Quote:

RedOne, did you check out the Advanced Gmax Tutorials at RenHelp? They explain a LOT and are very helpful.


I learned a by using the RenHelp. I shall read that one. only you talk about things that is already new for me like welding. And I am thinking about how to use extrude in the map.

Thx

GrTz Rene
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Release : Ultimate advantage skins! Glowing C4!
Next Topic: GPS HUD request
Goto Forum:
  


Current Time: Wed Dec 04 03:45:35 MST 2024

Total time taken to generate the page: 0.00907 seconds