Command and Conquer: Renegade Official Forums: Mod Forum

Home » Renegade Discussions » Mod Forum » Eddital mesh in renx

Show: Today's Messages :: Polls :: Message Navigator

Re: Eddital mesh in renx [message #163381 is a reply to message #163377]

Fri, 15 July 2005 16:48

danpaul88
Messages: 5795
Registered: June 2004
Location: England

Karma:

General (5 Stars)

uhm, when you create the plane (using a plane as an example) the default settings are 3 Length and 3 Width Segments. This means the plane is 3 polygons wide and 3 polygons long.

If when you first make your plane you increase the value of the Length or Width it chops the plane into smaller segments, creating more polygons and therefore more dots.

For example 5 Wide and 5 Long will give 25 dots.

Hope this helps, its hard to explain simply....

http://steamsignature.com/card/1/76561197975867233.png

Report message to a moderator

[Message index]

		Eddital mesh in renx By: Fleetatks on Fri, 15 July 2005 16:35
		Re: Eddital mesh in renx By: danpaul88 on Fri, 15 July 2005 16:40
		Re: Eddital mesh in renx By: Fleetatks on Fri, 15 July 2005 16:45
		Re: Eddital mesh in renx By: danpaul88 on Fri, 15 July 2005 16:48
		Re: Eddital mesh in renx By: Fleetatks on Fri, 15 July 2005 16:51
		Re: Eddital mesh in renx By: Fleetatks on Fri, 15 July 2005 16:59

Previous Topic:	Using editted .mix files
Next Topic:	To anyone who has been having scripts.dll 2.1.2 issues

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Jun 20 11:09:48 MST 2025

Total time taken to generate the page: 0.03006 seconds