Renegade Public Forums
C&C: Renegade --> Dying since 2003™, resurrected in 2024!
Home » Renegade Discussions » Mod Forum » Command & Conquer : Reborn :: NOD HARPY
Command & Conquer : Reborn :: NOD HARPY [message #141286] Tue, 01 March 2005 11:18 Go to previous messageGo to previous message
Sir Phoenixx is currently offline  Sir Phoenixx
Messages: 2510
Registered: February 2003
Location: Behind You!
Karma:
General (2 Stars)

The model looks good. It could use more detail on the shaft, it's not just one large cylinder in the middle, it needs to be about half as thick, with a smaller L shaped "arm" under each blade connecting them to a base/plate (swash plate) about halfway up the shaft. The bottom part of the tail would look much better rounded instead of angular/boxy. The blades look like they were just cloned and flipped across to make the one on the opposite side, they need to be rotated around into place as they're cloned instead so that they have the highlight on the same edge.

The texture is alright, it needs more work. The rotor blades should be almost completely clean, with almost no visible dents and gouges. The rest of the texture shouldn't be so rough looking, it's an advanced helicopter, it should be metallic and/or flat black/grays/etc.


.:Red Alert: A Path Beyond Modeler:.
E-mail: sirphoenixx@gmail.com
AIM: Sir Phoenixx
ICQ: 339325768
MSN: sirphoenixx@hotmail.com
Yahoo: sirphoenix86
If anyone needs any help with using 3dsmax, or gmax feel free to contact me.

My Gallery: sir-phoenixx.deviantart.com/gallery
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Yay! More questions!
Next Topic: LevelEdit Sounds + Lighting Help
Goto Forum:
  


Current Time: Sun Nov 17 19:22:10 MST 2024

Total time taken to generate the page: 0.01135 seconds