Command and Conquer: Renegade Official Forums: Mod Forum » RenX Crashed when I try to display a texture

Home » Renegade Discussions » Mod Forum » RenX Crashed when I try to display a texture

Show: Today's Messages :: Polls :: Message Navigator

RenX Crashed when I try to display a texture [message #55902]

Tue, 25 November 2003 16:43

Jaspah
Messages: 1478
Registered: July 2003
Location: Syracuse, New York

Karma: 0

General (1 Star)

I'm working on my map, when I have to texture it, a note comes up and says "RenX has experienced a error" then after it comes a "fail to read memory".

Do you have any ideas?

I really want to get my map going. Sad

Report message to a moderator

RenX Crashed when I try to display a texture [message #55909]

Tue, 25 November 2003 18:02

SuperFlyingEngi
Messages: 1756
Registered: November 2003

Karma: 0

General (1 Star)

Well, I don't know about RenX, but the problem might be the computer.
First, always restart a computer first if it gives you a memory error message. This often solves the problem.
If that doesnt work, make sure you have enough memory to run it.
And this may or may not work, but if your computer is decked out with spyware, that might slow it down a lot Mad

, so download Spybot: Search and Destroy to get rid of it. Anything beyond that is also beyond me. Confused

"To announce that there must be no criticism of the President, or that we are to stand by the President, right or wrong, is not only unpatriotic and servile, but is morally treasonable to the American public." -- Theodore Roosevelt (1918)

"The danger to political dissent is acute where the Government attempts to act under so vague a concept as the power to protect "domestic security." Given the difficulty of defining the domestic security interest, the danger of abuse in acting to protect that interest becomes apparent. --U.S. Supreme Court decision (407 U.S. 297 (1972)

The Liberal Media At Work
An objective look at media partisanship

Report message to a moderator

RenX Crashed when I try to display a texture [message #55913]

Tue, 25 November 2003 18:48

--oo00o00oo--
Messages: 180
Registered: June 2003

Karma: 0

Recruit

this has happened to my a fe times when i tried to apply the texture. so when it asks you if u would like to attempt to save, just save it and then load up the autoback. u should be right where u left off.(aply the texture first, then try to display it. if it crashes then save to the autoback. reopen andl oad the autoback. u should be at the point to where u havethe texture apllied but not displayed. just open the materail editor and hit display. it should not crash on u then, didnt for me.)

Report message to a moderator