Command and Conquer: Renegade Official Forums: Mod Forum

Home » Renegade Discussions » Mod Forum » Blending 3 textures

Show: Today's Messages :: Polls :: Message Navigator

Re: Blending 3 textures [message #478776 is a reply to message #478736]

Sat, 19 January 2013 23:30

Gen_Blacky
Messages: 3250
Registered: September 2006

Karma:

General (3 Stars)

Mauler wrote on Fri, 18 January 2013 02:58

Painting three passes on one mesh is just plain wrong... I would detach the area you want to blend the field into and apply a 2 pass blend... having three is just going to cause more trouble than it's worth.. you might have to move around some vertices and possibly extrude a bit to get a clean edge to blend.

Also not bad for a first map.. much better than 80% of what's out there haha! Thumbs Up

This

http://s18.postimage.org/jc6qbn4k9/bricks3.png

Report message to a moderator

[Message index]

		Blending 3 textures By: c0vert7 on Thu, 17 January 2013 19:07
		Re: Blending 3 textures By: c0vert7 on Thu, 17 January 2013 19:10
		Re: Blending 3 textures By: Aircraftkiller on Thu, 17 January 2013 20:41
		Re: Blending 3 textures By: c0vert7 on Thu, 17 January 2013 20:50
		Re: Blending 3 textures By: Mauler on Fri, 18 January 2013 02:58
		Re: Blending 3 textures By: Gen_Blacky on Sat, 19 January 2013 23:30
		Re: Blending 3 textures By: zunnie on Fri, 18 January 2013 03:05
		Re: Blending 3 textures By: c0vert7 on Fri, 18 January 2013 05:41
		Re: Blending 3 textures By: Mauler on Sat, 19 January 2013 22:29

Previous Topic:	Co-op Spawn vehicles through command
Next Topic:	Renegade's Campaign files

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Nov 06 22:48:28 MST 2025

Total time taken to generate the page: 0.00733 seconds