| Re: Treats [message #436253 is a reply to message #436251] |
Wed, 08 September 2010 07:35   |
Reaver11
Messages: 888
Registered: April 2007
Karma:
|
Colonel |
|
|
It is possbile but to get everything correct is a pain.
What you do is the following once your treads(model) are done you either uvw unwrap them or give the a UV map with the cylindrical setting.
Problem with the second methode is that it is not easy to setup the UV map correctly. Also I personnaly havent tried UVW unwrapping them yet. Which I will try out soon.
If you use the second methode make sure the sides of your treads look decend.
Also it is very tricky to get the ending stops correct on the treads.
You will see that the front and the back of the treads are kinda stretchy.
So yes it is possible saddly I havent good it in a perfect state.
I hope this answers a big part of your problem if not than I'll try to write it out better.
[Updated on: Wed, 08 September 2010 07:36] Report message to a moderator |
|
|
|
Search
Help
Members
Register
Login
Home
