Command and Conquer: Renegade Official Forums: Mod Forum » CLOSED well not closed butdont need no more help on this

Home » Renegade Discussions » Mod Forum » CLOSED well not closed butdont need no more help on this

Show: Today's Messages :: Polls :: Message Navigator

Re: How Do I Cut 42 Boxe's Out In Gmax To Make A Tower [message #307740 is a reply to message #307736]

Thu, 03 January 2008 21:42

R315r4z0r
Messages: 3836
Registered: March 2005
Location: New York

Karma:

General (3 Stars)

That is because you are not confirming that you want the middle taken out.

Try this:
Do it again and take the middle out. Then click off of the mesh. Then click back on to the tower mesh again and open boolean again. It will probably already be opened when you click onto the mesh, don't worry, open it again. Then use the new boolean to take out the other smaller boxes.

[Updated on: Thu, 03 January 2008 21:42]

Report message to a moderator

[Message index]

		CLOSED well not closed butdont need no more help on this By: cpjok on Wed, 02 January 2008 20:28
		Re: How Do I Cut 42 Boxe's Out In Gmax To Make A Tower By: cpjok on Wed, 02 January 2008 20:42
		Re: How Do I Cut 42 Boxe's Out In Gmax To Make A Tower By: Jerad2142 on Thu, 03 January 2008 01:26
		Re: How Do I Cut 42 Boxe's Out In Gmax To Make A Tower By: Dealman on Thu, 03 January 2008 13:05
		Re: How Do I Cut 42 Boxe's Out In Gmax To Make A Tower By: R315r4z0r on Thu, 03 January 2008 13:35
		Re: How Do I Cut 42 Boxe's Out In Gmax To Make A Tower By: fatalcry on Thu, 03 January 2008 01:27
		Re: How Do I Cut 42 Boxe's Out In Gmax To Make A Tower By: crazfulla on Thu, 03 January 2008 10:12
		Re: How Do I Cut 42 Boxe's Out In Gmax To Make A Tower By: cpjok on Thu, 03 January 2008 21:29
		Re: How Do I Cut 42 Boxe's Out In Gmax To Make A Tower By: R315r4z0r on Thu, 03 January 2008 21:42
		Re: How Do I Cut 42 Boxe's Out In Gmax To Make A Tower By: cpjok on Sat, 05 January 2008 16:55
		Re: How Do I Cut 42 Boxe's Out In Gmax To Make A Tower By: cpjok on Sat, 05 January 2008 18:19

Previous Topic:	Animation names
Next Topic:	Just wondering if you guys now if this is possible

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Jan 08 14:02:45 MST 2025

Total time taken to generate the page: 0.00703 seconds