Command and Conquer: Renegade Official Forums: Mod Forum

Home » Renegade Discussions » Mod Forum » Selecting edges

Show: Today's Messages :: Polls :: Message Navigator

Selecting edges [message #100861]

Sun, 11 July 2004 01:20

Dan
Messages: 395
Registered: August 2003
Location: UK

Karma:

Commander

When you write 0.0000001 in the extrude box then click on extrude, it does extrude the edge/polygon, but since gmax does go any more precise than to 3 decimal places, it doesnt move, but is still extruded. So after you have extruded them, just move them to where you want, and it should extrude properly.

Report message to a moderator

[Message index]

		Selecting edges By: flyingfox on Sat, 10 July 2004 20:04
		Selecting edges By: SuperFlyingEngi on Sat, 10 July 2004 20:46
		Selecting edges By: PermaGrin on Sat, 10 July 2004 21:52
		Selecting edges By: Spice on Sat, 10 July 2004 22:39
		Selecting edges By: flyingfox on Sat, 10 July 2004 23:07
		Selecting edges By: Dan on Sun, 11 July 2004 01:20

Previous Topic:	Mod problem.
Next Topic:	Renegade: A New Hope Update

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Nov 08 13:26:54 MST 2025

Total time taken to generate the page: 0.00702 seconds